当前位置:二级建造师继续教育(综合练习)题库

问题:

[单选] 预制构件制作模具质量验收中,弯曲的允许误差为()

A . 1mm
B . 2mm
C . 3mm
D . 4mm

What are three valid reasons to assign ports to VLANs on a switch?() to make VTP easier to implement。 to isolate broadcast traffic。 to increase the size of the collision domain。 to allow more devices to connect to the network。 to logically group hosts according to function。 to increase network security。 利用次级点火波形重叠可诊断出()。 分电器凸轮磨损情况。 断电器触电闭合角的大小。 混合气浓度是否合适。 喷油器是否堵塞。 Which feature is a potential security weakness of a traditional stateful firewall?() It cannot support UDP flows.。 It cannot ensure each TCP connection follows a legitimate TCP three-way handshake.。 It cannot detect application-layer attacks.。 The status of TCP sessions is retained in the state table after the sessions terminate.。 擅自(变相)关闭或故意损坏行车安全装备;人为销毁监控资料,属于()问题。 红线。 A1。 A2。 B。 无机结合料稳定材料无侧限抗压强度试件的高径比为(1:1),对细粒土、中粒土和粗粒土,试件的数量分别不少于()个。 9、9和13。 6、9和9。 6、13和13。 6、9和13。 预制构件制作模具质量验收中,弯曲的允许误差为()
参考答案:

  参考解析

本题暂无解析

在线 客服